Modern replacement magazines are purpose-built for one caliber only. One side of the magazine was marked for 7.65 mm and featured seven holes showing the positions that cartridges of that size would occupy when loaded the other side had similar holes and markings for 9 mm cartridges. 380 ACP) ammunition and were interchangeable between pistols of either calibre. Īt least the earlier Ortgies magazines could accommodate both 7.65 and 9 mm Kurz, (aka. To disengage the safety, a shooter simply would squeeze the grip, pressing the lever forward and locking it flush with the back of the frame. Thus, engaging the safety simultaneously reduced tension on the firing pin spring. The safety was a lever inset into the back of the grip and, with the gun cocked, forced backward out of the grip into the 'safe' position by spring tension from the firing pin upon depression of a button under the slide.

Unusual design features included the safety and the magazine. As in early Colt and Browning pocket pistols, the Ortgies striker also operated as an ejector as the slide traveled backwards after discharge. The hammerless action depended on a spring-loaded striker to fire the cartridge. Metal components were forged or machined, and assembly in general made no use of screws, even securing the wooden grips with metal clips, although some examples do incorporate a single screw for that purpose. Although not expensive, at the time it was of advanced design and high quality construction with relatively few parts, well sealed against dirt. The pistol was produced in 6.35 mm, 7.65 mm, and 9 mm Kurz variants.

Deutsche werke ortgies serial numbers